Configuration
To configure PoE on an ACX2000 router:
CLI Quick
Configuration
To quickly configure this example, copy the following commands, paste them into a text
file, remove any line breaks, change any details necessary to match your network
configuration, and then copy and paste the commands into the CLI at the [edit] hierarchy
level.
set poe management high-power guard-band 19
set poe interface ge-0/1/3 priority high maximum-power 65 telemetries
Step-by-Step
Procedure
The following example requires you to navigate various levels in the configuration
hierarchy. For instructions on how to do that, see Using the CLI Editor in Configuration
Mode in the CLI User Guide.
To configure PoE:
1. Set the PoE management mode to high-power.
[edit]
user@host# set poe management high-power
NOTE:
• Set the PoE management mode to high-power only when the power
requirement is more than 32 W and up to 65 W. If the power
requirement is less than or equal to 32 W, then you do not need to set
the PoE management mode to high-power.
• The default management mode is static. In this mode, the power
sourcing equipment can deliver power up to 32 W.
2. Reserve power wattage in case of a spike in PoE consumption.
[edit]
user@host# set poe guard-band 19
3. Enable PoE.
[edit]
user@host# edit poe interface ge-0/1/3
4. Set the power port priority.
[edit poe interface ge-0/1/3]
user@host# set priority high
5. Set the maximum PoE power for a port.
Copyright © 2017, Juniper Networks, Inc.146
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
