Juniper ACX2000 Configuration Guide

Table 137: show class-of-service interface Output Fields (continued)
Field DescriptionField Name
The Interface flags field provides information about the physical interface and displays one or more
of the following values:
• Admin-Test—Interface is in test mode and some sanity checking, such as loop detection, is disabled.
• Disabled—Interface is administratively disabled.
• Down—A hardware failure has occurred.
• Hardware-Down—Interface is nonfunctional or incorrectly connected.
• Link-Layer-Down—Interface keepalives have indicated that the link is incomplete.
• No-Multicast—Interface does not support multicast traffic.
• No-receive No-transmit—Passive monitor mode is configured on the interface.
• Point-To-Point—Interface is point-to-point.
• Pop all MPLS labels from packets of depth—MPLS labels are removed as packets arrive on an
interface that has the pop-all-labels statement configured. The depth value can be one of the
following:
• 1—Takes effect for incoming packets with one label only.
• 2—Takes effect for incoming packets with two labels only.
• [ 1 2 ]—Takes effect for incoming packets with either one or two labels.
• Promiscuous—Interface is in promiscuous mode and recognizes frames addressed to all physical
addresses.
• Recv-All-Multicasts—Interface is in multicast promiscuous mode and provides no multicast filtering.
• SNMP-Traps—SNMP trap notifications are enabled.
• Up—Interface is enabled and operational.
Interface flags
The Logical interface flags field provides information about the logical interface and displays one or
more of the following values:
• ACFC Encapsulation—Address control field Compression (ACFC) encapsulation is enabled
(negotiated successfully with a peer).
• Device-down—Device has been administratively disabled.
• Disabled—Interface is administratively disabled.
• Down—A hardware failure has occurred.
• Clear-DF-Bit—GRE tunnel or IPsec tunnel is configured to clear the Don't Fragment (DF) bit.
• Hardware-Down—Interface protocol initialization failed to complete successfully.
• PFC—Protocol field compression is enabled for the PPP session.
• Point-To-Point—Interface is point-to-point.
• SNMP-Traps—SNMP trap notifications are enabled.
• Up—Interface is enabled and operational.
Flags
Encapsulation on the logical interface.Encapsulation
Administrative state of the interface (Up or Down)Admin
Status of physical link (Up or Down).Link
Protocol configured on the interface.Proto
2425Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English