Table 140: show dhcp relay binding Output Fields (continued)
Level of
OutputField DescriptionField Name
brief detailState of the DHCP relay address binding table on the DHCP
client:
• BOUND—Client has an active IP address lease.
• INIT—Initial state.
• REBINDING—Client is broadcasting a request to renew the
IP address lease.
• RELEASE—Client is releasing the IP address lease.
• RENEWING—Client is sending a request to renew the IP
address lease.
• REQUESTING—Client is requesting a DHCP server.
• SELECTING—Client is receiving offers from DHCP servers.
State
briefIncoming client interface.Interface
detailDate and time at which the client’s IP address lease expires.Lease Expires
detailNumber of seconds in which the lease expires.Lease Expires in
detailDate and time at which the client’s IP address lease started.Lease Start
detailLease time violation has occurred.Lease time violated
detailClient’s incoming interface.Incoming Client Interface
detailIP address of the DHCP server.Server IP Address
detailInterface of the DHCP server.Server Interface
detailIP address of BOOTP relay.Bootp Relay Address
All levelsType of DHCP packet processing performed on the router:
• active—Router actively processes and relays DHCP packets.
• passive—Router passively snoops DHCP packets passing
through the router.
Type
All levelsDate and time at which the client’s IP address lease expires.Lease expires at
detailName of dual stack that is configured with the DHCP binding.Dual Stack Group
detailPrefix of dual stack DHCPv6 peer.Dual Stack Peer Prefix
detailAddress of the dual stack DHCPv6 peer.Dual Stack Peer Address
2457Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
