Juniper ACX2000

Table 144: ATM show interfaces Output Fields (continued)
Level of OutputField DescriptionField Name
All levelsInformation about the logical interface. Possible values are described in the
“Logical Interface Flags” section under Common Output Fields Description.
Flags
None specifiedNumber of packets received on the logical interface.Input packets
None specifiedNumber of packets transmitted on the logical interface.Output packets
All levelsEncapsulation on the logical interface.Encapsulation
detail extensiveTotal number of bytes and packets received and transmitted on the logical
interface. These statistics are the sum of the local and transit statistics. When
a burst of traffic is received, the value in the output packet rate field might briefly
exceed the peak cell rate. It takes a while (generally, less than 1 second) for this
counter to stabilize.
Traffic statistics
detail extensiveStatistics for traffic received from and transmitted to the Routing Engine. When
a burst of traffic is received, the value in the output packet rate field might briefly
exceed the peak cell rate. It takes a while (generally, less than 1 second) for this
counter to stabilize.
Local statistics
detail extensiveStatistics for traffic transiting the router. When a burst of traffic is received, the
value in the output packet rate field might briefly exceed the peak cell rate. It
takes a while (generally, less than 1 second) for this counter to stabilize.
Transit statistics
None specifiedNumber of packets received on the logical interface.Input packets
None specifiedNumber of packets transmitted on the logical interface.Output packets
briefProtocol family configured on the logical interface. If the protocol is inet, the IP
address of the interface is also displayed.
protocol-family
detail extensive noneProtocol family configured on the logical interface.Protocol
detail extensive noneMTU size on the logical interface.MTU
detail extensiveUnique number for use by Juniper Networks technical support only.Generation
detail extensiveRouting table in which the logical interface address is located. For example, 0
refers to the routing table inet.0.
Route table
detail extensive noneInformation about the protocol family flags. Possible values are described in
the “Family Flags” section under Common Output Fields Description.
Flags
detail extensive noneInformation about the address flags. Possible values are described in the
“Addresses Flags” section under Common Output Fields Description.
Addresses, Flags
detail extensive noneIP address of the remote side of the connection.Destination
detail extensive noneIP address of the logical interface.Local
2483Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands