To Next Page

To Previous Page

List of Sample Output show isis interface on page 2696

show isis interface brief on page 2696

show isis interface detail on page 2696

show isis interface extensive on page 2696

Output Fields Table 158 on page 2694 describes the output fields for the show isis interface command.

Output fields are listed in the approximate order in which they appear.

Table 158: show isis interface Output Fields

Level of OutputField DescriptionField Name

detailName of the interface.interface-name

detailRouting device selected by other routers that is responsible for sending link-state

advertisements that describe the network. Used only on broadcast networks.

Designated router

detailInterface index assigned by the Junos OS kernel.Index

detailInternal implementation information.State

detailCircuit identifier.

NOTE: Each IS-IS interface is assigned a circuit ID value to identify the interface

within the linkstate database. All interfaces (loopback, broadcast, and so on)

and all point-to-point links share the locally significant value of 0x01, and this

value is not incremented.

Circuit id

detailCircuit type:

• 1—Level 1 only

• 2—Level 2 only

• 3—Level 1 and Level 2

Circuit type

detailInterval between link-state PDUs sent from the interface.LSP interval

detail extensiveInterval between complete sequence number PDUs sent from the interface.CSNP interval

detailSystem identifier.Sysid

none briefInterface through which the adjacency is made.Interface

All levelsLevel:

• 1—Level 1 only

• 2—Level 2 only

• 3—Level 1 and Level 2

NOTE: The default IS-IS level on loopback interfaces are always same as the

IS-IS level configured on other IS-IS interfaces in a router. You can also configure

IS-IS level on loopback interfaces per your requirement.

L or Level

none briefCircuit identifier.CirID

ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Configuration Guide

Other manuals for Juniper ACX2000