Juniper ACX2000 Configuration Guide

show oam ethernet connectivity-fault-management interfaces detail(Connection
Protection TLV Configured) on page 2775
show oam ethernet connectivity-fault-management interfacesextensive on page 2776
show oam ethernet connectivity-fault-management interfaces level on page 2777
showoam ethernet connectivity-fault-management interfaces (trunk ports) on page2777
Output Fields Table 178 on page 2769 lists the output fields for the show oam ethernet
connectivity-fault-management interfaces command. Output fields are listed in the
approximate order in which they appear.
Table 178: show oam ethernet connectivity-fault-management interfaces Output Fields
Level of OutputField DescriptionField Name
All levelsInterface identifier.Interface
All levelsLocal interface status.Interface status
All levelsLocal link status. Up, down, or oam-down.Link status
detail extensiveMaintenance domain name.Maintenance
domain name
detail extensiveMaintenance domain name format configured.Format
(Maintenance
domain)
All levelsMaintenance domain level configured.Level
detail extensiveMaintenance association name.Maintenance
association name
detail extensiveMaintenance association name format configured.Format
(Maintenance
association)
detail extensiveContinuity-check status.Continuity-check
status
detail extensiveStatus of alarm indication signal (AIS). active or in-active.Ethernet-ais status
detail extensiveContinuity-check message interval.Interval
detail extensiveLost continuity-check message threshold.Loss-threshold
detail extensiveStatus of the interface status TLV, if configured on the MEP interface: none, up,
down, testing, unknown, dormant, notPresent, lowerLayerDown
Interface status
TLV
detail extensiveStatus of the port status TLV, if configured on the MEP interface: none, no, yesPort status TLV
2769Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English