inter—(Optional) Display interarea routes.
intra—(Optional) Display intra-area routes.
instance (default | ipv4-multicast | instance-name)—(Optional) Display entries for the
default routing instance, the IPv4 multicast routing instance, or for the specified
routing instance.
logical-system (default | ipv4-multicast | logical-system-name)—(Optional) Perform
this operation on the default logical system, the IPv4 multicast logical system, or on
a particular logical system.
network—(Optional) Display routes to networks.
no-backup-coverage—(Optional) Display routes with no backup coverage.
realm (ipv4-multicast | ipv4-unicast | ipv6-multicast)—(OSPFv3 only) (Optional)
Display entries in the routing table for the specified OSPFv3 realm, or address family.
Use the realm option to specify an address family for OSPFv3 other than IPv6 unicast,
which is the default.
router—(Optional) Display routes to all routers.
topology (default | ipv4-multicast | topology-name)—(OSPFv2 only) (Optional) Display
routes for the default OSPF topology, IPv4 multicast topology, or for a particular
topology.
transit—(Optional) (OSPFv3 only) Display OSPFv3 routes to pseudonodes.
Required Privilege
Level
view
List of Sample Output show ospf route on page 2860
show ospf route detail on page 2861
show ospf route extensive on page 2861
show ospf3 route on page 2861
show ospf3 route detail on page 2862
show ospf route topology voice on page 2862
Output Fields Table 191 on page 2858 list the output fields for the show (ospf | ospf3) route command.
Output fields are listed in the approximate order in which they appear.
Table 191: show (ospf | ospf3) route Output Fields
Output LevelField DescriptionField Name
All levelsName of the topology.Topology
All levelsDestination of the route.Prefix
Copyright © 2017, Juniper Networks, Inc.2858
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
