Table 232: show services rpm rfc2544-benchmarking test-id Output Fields (continued)
Level of OutputField DescriptionField Name
detailDetails of the configured test ID.Test Configuration
detailMode configured for the test. Test modes are Initiate-and-Terminate and Reflect.Test mode
detailPeriod in seconds for which the test has been performed.Duration in seconds
detailThe underlying service on which the test is run. Test families are:
• INET: Indicates that the test is run on a IPV4 service.
• CCC: Indicates that the test is run on a circuit cross-connect (CCC) or
pseudowire service.
Test family
detail(ACX Series routers only) Name of the routing instance for the testRouting Instance
Name
detailDetails of the configured inet family for an IPv4 serviceInet family
Configuration
detailName of the egress interface from which the test frames are sentEgress Interface
detailSource IPv4 address used in the IP header of the generated test frame.Source ipv4
address
detailDestination IPv4 address used in the IP header of the generated test frame.Destination ipv4
address
detailSource UDP port number used in the UDP header of the generated test frame.Source udp port
detailDestination UDP port number used in the UDP header of the generated test
frame.
Destination udp
port
detailDetails of the configured CCC family for an Ethernet serviceCcc family
Configuration
detail(ACX Series routers only) Source MAC address used in generated test frames
for a CCC or Ethernet pseudowire service.
Source MAC
address
detail(ACX Series routers only) Destination MAC address used in generated test
frames for a CCC or Ethernet pseudowire service.
Destination MAC
address
detail(ACX Series routers only) Inner VLAN ID for test-frames.Ivlan-id
detail(ACX Series routers only) Outer VLAN ID for test-frames.Ovlan-id
detailTest is run in the egress direction of the interface (NNI)Direction egress
detailTest is run in the ingress direction of the interface (UNI)Direction ingress
3163Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands
To Next Page
Loading...
Need help?
General
