Table 232: show services rpm rfc2544-benchmarking test-id Output Fields (continued)
Level of OutputField DescriptionField Name
detail(ACX Series routers only) Details of the throughput testRfc2544
throughput test
information
detailPercentage of the steady state load for the test.Initial test load
percentage
detailMode of the test iteration: Binary or step-down.Test iteration mode
detailThe test step percentage for tests. If not specified, the default step-percent is
10 percent. This parameter is ignored for all type of tests other than frame-loss
tests.
Test iteration step
percent
detailThe theoretical limit of the media for the frame size configured for the test. This
value is typically set to the bandwidth of the server being tested.
Theoretical max
bandwidth
detailPacket size of the test frames in bytes.Test packet size:
detailNumber of the test iteration.Iteration
detailPeriod in seconds for which the test iteration is runDuration (sec)
detailAmount of time that has passed, in seconds, since the start of the test.Elapsed time
detailTotal count of packets-per-second (pps) transmitted during the test.pps
detailNumber of transmitted test packets.Tx Packets
detailNumber of received test packets.Rx Packets
detailNumber of transmitted bytes.Tx Bytes
detailNumber of received bytes.Rx Bytes
detailPercentage of throughput for the test iteration.Percentage
throughput
detailResults of the completed throughput test for a particular packet size.Result of the
iteration runs
(Throughput) :
detailNumber of the iteration with the highest throughout, among the listed iterations.Best iteration
detailPackets-per-second (pps) count of the iteration with the highest throughout,
among the listed iterations.
Best iteration (pps)
detailPercentage of throughput of the iteration with the highest throughout, among
the listed iterations.
Best iteration
throughput
Copyright © 2017, Juniper Networks, Inc.3164
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
