Juniper ACX2000

Table 232: show services rpm rfc2544-benchmarking test-id Output Fields (continued)
Level of OutputField DescriptionField Name
detail summaryConsolidated information of the throughput test.RFC2544
Throughput test
results summary
detail summarySize of the test packet in bytes.Packet Size
detail summaryTheoretical frame rate in packets-per-second.Theoretical rate
(pps)
detail summaryNumber of transmitted packets.Tx Packets
detail summaryNumber of received packets.Rx Packets
detail summaryThe offered throughput in percentage of the chosen service (such as Layer 3 or
Ethernet pseudowire).
Offered throughput
(percentage)
detail summaryAvailable bandwidth of the service based on the calculated throughput.Measured
bandwidth (kbps)
detail(ACX Series routers only) Details of the latency testRfc2544 latency
test information
:
detailTheoretical maximum bandwidth configured for the test. This value is typically
set to the bandwidth of the server being tested. Valid values are 1 Kbps through
1,000,000 Kbps (1 Gbps). The value defined is the highest bandwidth value
used for this test.
Theoretical max
bandwidth
detailPercentage of the steady state load for the test.Initial test load
percentage
detailPeriod in seconds for which the test has been performed.Duration in seconds
detailSize of the test packet in bytes.Test packet size
detailNumber of the test iteration.Iteration
detailPeriod in seconds for which the test iteration is run.Duration (sec)
detailAmount of time that has passed, in seconds, since the start of the test.Elapsed time
detailTotal count of packets-per-second (pps) transmitted during the test.pps
detailNumber of transmitted test packets.Tx Packets
detailNumber of received test packets.Rx Packets
detailDisplays the latency parameters.Latency
3165Copyright © 2017, Juniper Networks, Inc.
Chapter 42: Operational Commands