[edit interfaces ge-0/2/0]
user@host#set unit 0 family inet
8. Specify the address for the logical interface
[edit interfaces ge-0/2/0 unit 0 family inet]
user@host#set address 110.1.1.2/24
9. Configure the stateful interface, and enter edit mode for the interface.
[edit interfaces]
user@host#edit ge-0/2/1
10. Configure a description for the interface.
[edit interfaces ge-0/2/1]
user@host#set description to-ACX2
11. Configure a logical unit and specify the protocol family.
[edit interfaces ge-0/2/1]
user@host#set unit 0 family inet
12. Specify the address for the logical interface
[edit interfaces ge-0/2/1 unit 0 family inet]
user@host#set address 110.2.1.1/24
13. Configure the clock mode as boundary clock.
[edit protocols ptp]
user@host# set clock-mode boundary
14. Specify the PTP domain value.
[edit protocols ptp]
user@host# set domain 110
15. Configure the local slave interface from which the boundary master receives time
and passes it on to the configured clock clients.
[edit protocols ptp]
user@host# edit slave interface ge-0/2/0.0
16. Configure the upstream unicast PTP master clock source parameters.
[edit protocols ptp slave interface ge-0/2/0.0]
user@host# edit unicast-mode
17. Configure the encapsulation type for PTP packet transport.
[edit protocols ptp slave interface ge-0/2/0.0 unicast-mode]
user@host# set transport ipv4
Copyright © 2017, Juniper Networks, Inc.284
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
