Anritsu MS2840A - Page 1076

Chapter
３
Native Device Message List
3-50
Table 3.10.7-1 Spurious Emission Measurement function setting messages (Cont’d)
Function Command Query Response Remarks
Spurious Emission Time Domain Sweep Time
SPUR:TDOM:SWE:TIME
seconds_n
SPUR:TDOM:SWE:TIME? seconds_n
n :1 to 20
Spurious Emission Time Domain Detection
SPUR:TDOM:DET mode_n
SPUR:TDOM:DET? mode_n
n :1 to 20
Save Spurious Emission Parameter
MMEM:STOR:SPUR:TABL
integer
--- ---
Recall Spurious Emission Parameter
MMEM:LOAD:SPUR:TABL
integer
--- ---
Spurious Emission Continue
INIT:SPUR:PAUS:CONT
--- ---
Spurious Emission Pause Status Query
--- INIT:SPUR:PAUS:STAT? switch
switch :
= 1|0
Spurious Emission Configure
CONF:SPUR
---
---
Spurious Emission Initiate
INIT:SPUR --- ---
Low Phase Noise for Spurious Emission
Measurement
SPUR:SYNT:LPH switch
SPUR:SYNT:LPH? switch
switch : ON|OFF|1|0
Low Phase Noise Status Query
--- FREQ:SYNT:LPH:STAT? status
status : 1|0