Anritsu MS2840A - Page 421

2.9 ACP
2-411
2
SCPI Device Message Details
In ACP measurement (when ACP Result Type is ALL)
Two values of ref_carrier_a are output when ACP Reference is
BSIDes.
<integration_abs>,<total_carrier_a>,
<power_1>,<power_2>,<power_3>,<power_4>,
<power_5>,<power_6>,<power_7>,<power_8>,
<power_9>,<power_10>,<power_11>,<power_12>,
<ref_carrier_a>(,<ref_carrier_a>),
<lower_offset_1_rel>,<lower_offset_1_abs>,
<upper_offset_1_rel>,<upper_offset_1_abs>,
<lower_offset_2_rel>,<lower_offset_2_abs>,
<upper_offset_2_rel>,<upper_offset_2_abs>,
<lower_offset_3_rel>,<lower_offset_3_abs>,
<upper_offset_3_rel>,<upper_offset_3_abs>,
<lower_offset_4_rel>,<lower_offset_4_abs>,
<upper_offset_4_rel>,<upper_offset_4_abs>,
<lower_offset_5_rel>,<lower_offset_5_abs>,
<upper_offset_5_rel>,<upper_offset_5_abs>,
<lower_offset_6_rel>,<lower_offset_6_abs>,
<upper_offset_6_rel>,<upper_offset_6_abs>,
<lower_offset_7_rel>,<lower_offset_7_abs>,
<upper_offset_7_rel>,<upper_offset_7_abs>,
<lower_offset_8_rel>,<lower_offset_8_abs>,
<upper_offset_8_rel>,<upper_offset_8_abs>
(n=1 or when omitted)
When the result mode is “B”.
When Offset Setup Mode is Normal
When the Carrier Number is 1 and when only the Offset-1 is On.
<ref_carrier_b>,<lower_offset_1_rel>,
<upper_offset_1_rel>
Other than the above
0.0,<total_carrier_b>,0.0,<ref_carrier_b>,
<lower_offset_1_rel>,<lower_offset_1_abs>,
<upper_offset_1_rel>,<upper_offset_1_abs>,
<lower_offset_2_rel>,<lower_offset_2_abs>,
<upper_offset_2_rel>,<upper_offset_2_abs>,
<lower_offset_3_rel>,<lower_offset_3_abs>,
<upper_offset_3_rel>,<upper_offset_3_abs>
(n = 1 or when omitted, and when ACP Reference is other than
Both Sides of Carriers)
0.0,<total_carrier_b>,
<ref_carrier_lower>,<ref_carrier_upper>,
<lower_offset_1_rel>,<lower_offset_1_abs>,