Anritsu MS2840A - Page 422

Chapter 2 SCPI Device Message Details
2-412
<upper_offset_1_rel>,<upper_offset_1_abs>,
<lower_offset_2_rel>,<lower_offset_2_abs>,
<upper_offset_2_rel>,<upper_offset_2_abs>,
<lower_offset_3_rel>,<lower_offset_3_abs>,
<upper_offset_3_rel>,<upper_offset_3_abs>
(n = 1 or when omitted, and when ACP Reference is Both Sides of
Carriers)
<channel_1_rel>,<channel_1_abs>,
<channel_2_rel>,<channel_2_abs>,
......
<channel_12_rel>,<channel_12_abs>,
<lower_offset_1_rel>,<lower_offset_1_abs>,
<upper_offset_1_rel>,<upper_offset_1_abs>,
<lower_offset_2_rel>,<lower_offset_2_abs>,
<upper_offset_2_rel>,<upper_offset_2_abs>,
<lower_offset_3_rel>,<lower_offset_3_abs>,
<upper_offset_3_rel>,<upper_offset_3_abs>
(in n=2)
When Offset Setup Mode is Advanced
When Carrier Number = 1 AND only Offset-1 = On
<ref_carrier_b>,<lower_offset_1_rel>,
<upper_offset_1_rel>
Other than the above
0.0,<total_carrier_b>,0.0,<ref_carrier_b>,
<lower_offset_1_rel>,<lower_offset_1_abs>,
<upper_offset_1_rel>,<upper_offset_1_abs>,
<lower_offset_2_rel>,<lower_offset_2_abs>,
<upper_offset_2_rel>,<upper_offset_2_abs>,
<lower_offset_3_rel>,<lower_offset_3_abs>,
<upper_offset_3_rel>,<upper_offset_3_abs>,
<lower_offset_4_rel>,<lower_offset_4_abs>,
<upper_offset_4_rel>,<upper_offset_4_abs>,
<lower_offset_5_rel>,<lower_offset_5_abs>,
<upper_offset_5_rel>,<upper_offset_5_abs>,
<lower_offset_6_rel>,<lower_offset_6_abs>,
<upper_offset_6_rel>,<upper_offset_6_abs>,
<lower_offset_7_rel>,<lower_offset_7_abs>,
<upper_offset_7_rel>,<upper_offset_7_abs>,
<lower_offset_8_rel>,<lower_offset_8_abs>,
<upper_offset_8_rel>,<upper_offset_8_abs>
(n=1 or when omitted, and when ACP Reference is not Both Sides
of Carriers)