Anritsu MS2840A - Page 951

2.17 Configuring Batch Measurement Settings
2-941
2
SCPI Device Message Details
Table 2.17-13 Parameter List Settings (IM Measurement – SPA Settings)
Parameter Attribute Name Setting Attribute Value Setting
Relative Frequency
“Relative Freq.”
When this parameter is
used, the relative frequency
can be set from command
argument
<spa_freq>
as
the center frequency.
Value is described
in Hz units.
Center Frequency
“Center Freq.”
Value is described
in Hz units.
Spurious Mode
“Frequency Band Spurious
Mode”
“
Normal
”: Normal
“
Spurious
”: Spurious
Reference Level
“Reference Level”
Value is described
in dBm units.
Reference Level Offset
“Reference Level Offset”
“
On
”: On
“Off”: Off
Reference Level Offset Value
“Reference Level Offset
Value”
Value is described
in 0.01 dB units.
RBW Auto/Manual
“RBW Switch Time Domain”
“
Auto
”: Auto
“
Manual
”: Manual
VBW Auto/Manual
“VBW Switch Time Domain”
“
Auto
”: Auto
“
Manual
”: Manual
Attenuator Auto/Manual
“ATTN Switch”
“
Auto
”: Auto
“
Manual
”: Manual
RBW
“RBW Value Time Domain”
“
30Hz
”: 30 Hz
“
100Hz
”: 100 Hz
“
300Hz
”: 300 Hz
“
500Hz
”: 500 Hz
“
1kHz
”: 1 kHz
“
3kHz
”: 3 kHz
“
10kHz
”: 10 kHz
“
30kHz
”: 30 kHz
“
50 kHz
”: 50 kHz
“
100kHz
”: 100 kHz
“
300kHz
”: 300 kHz
“
1MHz
”: 1 MHz
“
2MHz
”: 2 MHz
“
3MHz
”: 3 MHz
“
5MHz
”: 5 MHz
“
10MHz
”: 10 MHz
“
20MHz
”: 20 MHz