Anritsu MS2840A - Page 952

Chapter 2 SCPI Device Message Detail
2-942
Table 2.17-13 Parameter List Settings (IM Measurement – SPA Settings) (Cont’d)
Parameter Attribute Name Setting Attribute Value Setting
VBW
“VBW Value Time Domain”
“
1Hz
”: 1 Hz
“
3Hz
”: 3 Hz
“
10Hz
”: 10 Hz
“
30Hz
”: 30 Hz
“
100Hz
”: 100 Hz
“
300Hz
”: 300 Hz
“
1kHz
”: 1 kHz
“
3kHz
”: 3 kHz
“
5 kHz
”:
5 kHz
“
10kHz
”: 10 kHz
“
30kHz
”: 30 kHz
“
100kHz
”: 100 kHz
“
300kHz
”: 300 kHz
“
1MHz
”: 1 MHz
“
3MHz
”: 3 MHz
“
10MHz
”: 10 MHz
“
Off
”: Off
Sweep Time
“Sweep Time Time Domain”
Value is described
in µs units.
Attenuator
“ATTN Value”
Value is described
in dB units.
Storage Mode
“Storage Mode A”
“
Lin Average
”: Lin Average
“
Average
”: Average
“
Max Hold
”: Max Hold
“
Min Hold
”: Min Hold
“
Off
”: Off
Storage Count
“Storage Count”
Describes the storage count.
Trace Points
“Trace Points Time Domain”
Describes the number of
trace points.
Detection
“Detection Time Domain”
“
Pos & Neg
”:
Pos & Neg
“
Positive
”: Positive
“
Negative
”: Negative
“
Sample
”: Sample
“
RMS
”: RMS