Juniper ACX2000 Configuration Guide

unicast-mode {
transport ipv4;
clock-source 110.1.1.250 local-ip-address 110.1.1.2;
}
}
}
master {
interface ge-0/1/4.0 {
multicast-mode {
transport ieee-802.3;
}
}
}
stateful {
interface ge-0/2/1.0 {
multicast-mode {
transport ieee-802.3 link-local;
}
}
}
After you have configured the device, enter the commit command in configuration mode.
Verifying the PTP over Ethernet Multicast Dynamic, Master, and Slave Settings
Confirm that the configuration is working properly.
•
Verifying the PTP Clock Details on page 286
•
Verifying the Lock Status of the Slave on page 287
•
Verifying the PTP Options on the Slave on page 287
•
Verifying the PTP Options and the Current Status of the Master on page 287
•
Verifying the Number and Status of the PTP Ports on page 287
•
Verifying PTP Statistics on page 288
Verifying the PTP Clock Details
Purpose Verify that the PTP clock is working as expected.
Action In operational mode, enter the run show ptp clock command to display comprehensive,
globally configured clock details.
Meaning The output displays the clock details, such as the encapsulation method used for
transmission of PTP traffic and the number of configured stateful or dynamic ports.
Although a dynamic port functions as either a slave or a master port, the value displayed
in the Stateful Ports field denotes the dynamic ports that you explicitly configured. The
number of dynamic ports is not computed and displayed in the fields that display the
explicitly configured master and slave ports. For more information about the run show
ptp clock operational command, see show ptp clock in the CLI Explorer.
Copyright © 2017, Juniper Networks, Inc.286
ACX Series Universal Access Router Configuration Guide

Juniper ACX2000 Specifications

General

Brand	Juniper
Model	ACX2000
Category	Network Router
Language	English