[edit protocols ptp slave]
user@host# edit hybrid
3. Configure the IP address of the master clock as 2.2.2.2 , and the interface ge-1/2/3.0
for hybrid mode on the slave.
[edit protocols ptp slave]
user@host# set interface ge-1/2/3.0 unicast-mode clock-source 2.2.2.2
Results Display the results of the configuration of hybrid mode with a user-defined mapping of
the PTP clock class to the ESMC quality level:
[edit protocols ptp slave]
user@host# show
clock-class-to-quality-level-mapping {
quality-level prc {
clock-class 80;
}
}
interface ge-1/2/3.0 unicast-mode clock-source 2.2.2.2
hybrid
Verification
•
Verifying That the Router Is Operating in Hybrid Mode on page 298
•
Verifying the Quality Level Change on the Transmit Side on page 299
•
Verifying Global Information Parameters After Mapping of the PTP Clock Class to the
ESMC Quality Level in Hybrid Mode on page 299
•
Verifying Global Information Parameters After Configuring User-Defined Mapping of
the PTP Clock Class to the ESMC Quality Level in Hybrid Mode on page 300
Verifying That the Router Is Operating in Hybrid Mode
Purpose Verify the current mode of operation of the slave.
Action In operational mode, enter the run show ptp hybrid command to display the current
configuration and current mode of operation of the slave.
In operational mode, enter the run show ptp hybrid config command to display the PTP
source to Synchronous Ethernet interface mappings.
In operational mode, enter the run show ptp hybrid status command to display the current
hybrid mode operational status.
Meaning The output displays the current configuration and current mode of operation of the slave.
For information about the run show ptp hybrid operational command, see show ptp
hybrid.
Copyright © 2017, Juniper Networks, Inc.298
ACX Series Universal Access Router Configuration Guide
To Next Page
Loading...
Need help?
General
