Infineon TRAVEO T2G - Page 1007

Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
PULLUP 2 Resistive pull up
For GPIO & UDB/DSI peripherals:
When D_OUT_EN = 1:
D_OUT = '0': Strong pull down
D_OUT = '1': Weak/resistive pull up
When D_OUT_EN = 0:
D_OUT = '0': High impedance
D_OUT = '1': High impedance
For peripherals other than GPIO & UDB/DSI:
When D_OUT_EN = 1:
D_OUT = '0': Strong pull down
D_OUT = '1': Strong pull up
When D_OUT_EN = 0:
D_OUT = '0': Weak/resistive pull up
D_OUT = '1': Weak/resistive pull up
PULLDOWN 3 Resistive pull down
For GPIO & UDB/DSI peripherals:
When D_OUT_EN = 1:
D_OUT = '0': Weak/resistive pull down
D_OUT = '1': Strong pull up
When D_OUT_EN = 0:
D_OUT = '0': High impedance
D_OUT = '1': High impedance
For peripherals other than GPIO & UDB/DSI:
When D_OUT_EN = 1:
D_OUT = '0': Strong pull down
D_OUT = '1': Strong pull up
When D_OUT_EN = 0:
D_OUT = '0': Weak/resistive pull down
D_OUT = '1': Weak/resistive pull down
OD_DRIVESLOW 4 Open drain, drives low
For GPIO & UDB/DSI peripherals:
When D_OUT_EN = 1:
D_OUT = '0': Strong pull down
D_OUT = '1': High Impedance
When D_OUT_EN = 0:
D_OUT = '0': High impedance
D_OUT = '1': High impedance
For peripherals other than GPIO & UDB/DSI:
When D_OUT_EN = 1:
D_OUT = '0': Strong pull down
D_OUT = '1': Strong pull up
When D_OUT_EN = 0:
D_OUT = '0': High Impedance
D_OUT = '1': High Impedance
1007
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers