Infineon TRAVEO T2G - 4.13.6.6 CM4_CM4 CTI_CTIINEN

Technical Reference Manual 002-29852 Rev. *B
4.13.6.6 CM4_CM4CTI_CTIINEN
Description:
CTI Trigger to Channel Enable Registers
Address:
0xE0042020
Offset:
0x20
Retention:
Retained
IsDeepSleep:
No
Comment:
The CTI Trigger to Channel Enable Registers enable the signaling of an event on CTM
channels when the core issues a trigger, CTITRIGIN, to the CTI. There is one register for each
of the eight CTITRIGIN inputs. Within each register there is one bit for each of the four
channels implemented. These registers do not affect the application trigger operations.
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:4] TRIGINEN [3:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0:3 TRIGINEN RW R 0 Enables a cross trigger event to the corresponding
channel when an CTITRIGIN is activated.
1 = enables the CTITRIGIN signal to generate an
event on the respective channel of the CTM.
There is one bit of the register for each of the four
channels. For example in register CTIINEN0,
TRIGINEN[0] set to 1 enables CTITRIGIN onto
channel 0.
0 = disables the CTITRIGIN signal from generating an
event on the respective channel of the CTM.
488
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers