Infineon TRAVEO T2G - 14.2.27.8 FLASHC_ECC_OVERRIDE

Technical Reference Manual 002-29852 Rev. *B
14.2.27.8 FLASHC_ECC_OVERRIDE
Description:
ECC Data In override information and control bits
Address:
0x4024F030
Offset:
0x30
Retention:
Not Retained
IsDeepSleep:
No
Comment:
The replacement can be either to the Code syndrome or the work flash syndrome. It knows to
replace only 8 bits (per 64) in code flash OR 7 bits (per 32) in work flash, therefore this option
is valid only for pgm64 command (Code) or pgm32 command (Work)
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name ECC_OVERRIDE_SYNDROME [7:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name ECC
_OVERR
IDE_CODE
[31:31]
ECC
_OVERR
IDE_WORK
[30:30]
None [29:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0:7 ECC_OVERRIDE
_SYNDROME
W R 0 The override syndrome itself to be used in case one of
the enables are set. It will take [7:0] in the case of
Code flash and [6:0] in the case of work flash, to
bypass the internal generated syndrome
30 ECC_OVERRIDE_WORK W R 0 0: no override. Using internal ECC engine to calculate
the ECC of the Work Flash
31 ECC_OVERRIDE_CODE W R 0 0: no override. Using internal ECC engine to calculate
the ECC of the Code Flash
972
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers