Infineon TRAVEO T2G - 19.5.2.4 PASS_TEST_CTL

Technical Reference Manual 002-29852 Rev. *B
19.5.2.4 PASS_TEST_CTL
Description:
Test control bits
Address:
0x409F0080
Offset:
0x80
Retention:
Not Retained
IsDeepSleep:
No
Comment:
Note: All bits besides 6, 8, 9 are reserved, and should not be modified by the user
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:7] TS_CAL_VI
_SEL [6:6]
TS_CAL_DI
ODE_PNP
_EN [5:5]
TS_CAL_DI
ODE_EN
[4:4]
TS_CAL
_VE_OUT
[3:3]
TS_CAL
_VB_OUT
[2:2]
None [1:1] TS_CAL
_CUR_IN
[0:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:13] TS_CAL
_SPARE
[12:12]
None [11:10] TS_CAL_CUR_SEL [9:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0 TS_CAL_CUR_IN RW R 0 External current input switch control, for Temperature
Sensor Calibration
2 TS_CAL_VB_OUT RW R 0 Voltage Base switch control, for Temperature Sensor
Calibration
3 TS_CAL_VE_OUT RW R 0 Voltage Emitter switch control, for Temperature Sensor
Calibration
4 TS_CAL_DIODE_EN RW R 0 Diode Enable, disconnect or connect the base and
collector terminal of the BJT
5 TS_CAL_DIODE_PNP
_EN
RW R 0 Enable signal for PNP transistor. This transistor will be
used only during calibration for accurate estimation of
chip temp.
0 = Turn PNP off
1 = Configure PNP as a diode (short base and
collector)
6 TS_CAL_VI_SEL RW R 0 Select current or voltage output on 'v_temp' pin, for
Temperature Sensor Calibration
CURRENT 0 Current is selected
VOLTAGE 1 Voltage is selected
8:9 TS_CAL_CUR_SEL RW R 0 Select the current going into the BJT, for Temperature
Sensor Calibration
I_1U 0 Select 1 uA
I_2U 1 Select 2 uA
I_5U 2 Select 5 uA
I_10U 3 Select 10 uA
12 TS_CAL_SPARE RW R 0 Spare
1127
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers