Technical Reference Manual 002-29852 Rev. *B
18.13.3.4 LIN_CH_CMD
Description:
Command
Address:
0x40508010
Offset:
0x10
Retention:
Retained
IsDeepSleep:
No
Comment:
The register fields are retained. When a LIN channel is disabled (CTL.ENABLED is set to '0'),
HW sets all the register fields to '0'.
The following restrictions apply when programming the commands:
- TX_HEADER and RX_HEADER are mutually exclusive; i.e. cannot both be set to '1'.
- TX_WAKEUP is mutually exclusive with all other commands.
- TX_RESPONSE and RX_RESPONSE are NOT mutually exclusive, but are evaluated in the
following order (of decreasing priority): TX_RESPONSE, RX_RESPONSE.
The CMD.TX_HEADER register field description provides all legal command sequences.
The break or wakeup detection is always enabled, regardless of CMD register setting.
Note: LIN mode supports all commands, UART mode supports the TX_HEADER and
RX_HEADER commands only.
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:3] TX
_WAKEUP
[2:2]
TX
_RESPON
SE [1:1]
TX
_HEADER
[0:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:10] RX
_RESPON
SE [9:9]
RX
_HEADER
[8:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers
To Next Page
Loading...
