EasyManua.ls Logo

Infineon TRAVEO T2G - 28.4.1.1.12 TCPWM_GRP_CNT_DT

Infineon TRAVEO T2G
1825 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical Reference Manual 002-29852 Rev. *B
28.4.1.1.12 TCPWM_GRP_CNT_DT
Description:
Counter PWM dead time register
Address:
0x40380030
Offset:
0x30
Retention:
Retained
IsDeepSleep:
No
Comment:
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name DT_LINE_OUT_L [7:0]
Bits 15 14 13 12 11 10 9 8
Name DT_LINE_OUT_H [15:8]
Bits 23 22 21 20 19 18 17 16
Name DT_LINE_COMPL_OUT [23:16]
Bits 31 30 29 28 27 26 25 24
Name DT_LINE_COMPL_OUT [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0:7 DT_LINE_OUT_L RW R 0 In PWM_DT mode, this field is used to determine the
low byte of the dead time before activating the PWM
line output signal 'line_out': amount of dead time
cycles in the counter clock domain.
In all other modes, the lower 3 bits of this field
determine pre-scaling of the selected counter clock.
Note: This field determines the low byte of the 16-bit
dead time before activating 'line_out' when parameter
GRP_AMC_PRESENT for advanced motor control is
set to 1. Otherwise the dead time is only 8 bit wide and
the same dead time specified by this DT_LINE_OUT_L
field is used before activating 'line_out' and
'line_compl_out'.
DIVBY1 0 Divide by 1 (other-than-PWM_DT mode)
DIVBY2 1 Divide by 2 (other-than-PWM_DT mode)
DIVBY4 2 Divide by 4 (other-than-PWM_DT mode)
DIVBY8 3 Divide by 8 (other-than-PWM_DT mode)
DIVBY16 4 Divide by 16 (other-than-PWM_DT mode)
DIVBY32 5 Divide by 32 (other-than-PWM_DT mode)
DIVBY64 6 Divide by 64 (other-than-PWM_DT mode)
DIVBY128 7 Divide by 128 (other-than-PWM_DT mode)
8:15 DT_LINE_OUT_H RW R 0 In PWM_DT mode, this field is used to determine the
high byte of the dead time before activating the PWM
line output signal 'line_out': amount of dead time
cycles in the counter clock domain.
In all other modes, this field has no effect.
Note: This field only exists when parameter
GRP_AMC_PRESENT for advanced motor control is
set to 1. Otherwise the dead time is only 8 bit wide and
the same dead time specified by field
DT_LINE_OUT_L is used before activating 'line_out'
and 'line_compl_out'.
1808
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers

Table of Contents

Other manuals for Infineon TRAVEO T2G

Related product manuals