EasyManua.ls Logo

Infineon TRAVEO T2G - 18.13.3.5 LIN_CH_TX_RX_STATUS

Infineon TRAVEO T2G
1825 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Technical Reference Manual 002-29852 Rev. *B
18.13.3.5 LIN_CH_TX_RX_STATUS
Description:
TX/RX status
Address:
0x40508060
Offset:
0x60
Retention:
Not Retained
IsDeepSleep:
No
Comment:
Default:
0x5000000
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name SYNC_COUNTER [7:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:18] RX_IN
[17:17]
TX_IN
[16:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:27] EN_OUT
[26:26]
None
[25:25]
TX_OUT
[24:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0:7 SYNC_COUNTER R W Undefined Synchronization counter in LIN channel clock periods.
After the receipt of a synchronization field, this fields
reflects the duration of the synchronization field.
Ideally, SYNC_COUNTER = 8*16 = 128 (the
synchronization fields consists of eight bit period of 16
LIN channel clock periods each).
- If SYNC_COUNTER is less than 128, the LIN
channel clock is too slow and the PERI/PCLK divider
value should be decreased.
- If SYNC_COUNTER is greater than 128, the LIN
channel clock is too fast and the PERI/PCLK divider
value should be increased.
The biggest master-slave clock discrepancy occurs
when the master is slow and the slave is fast or vice
versa. At a 0.5 percent master inaccuracy and a 14
percent slave inaccuracy, this results in the extreme
synchronization values of (.86 * 128) / 1.005 = 109.5
and (1.14 *128) / 0.995 = 146.6. We add a little margin
for a valid range of [106, 152].
Note: Only slave nodes with imprecise clocks require
clock resynchronization. Master and slave nodes with
precise clocks do NOT require clock
resynchronization.
16 TX_IN R W Undefined LIN transmitter input ('tx_in', 'lin_tx_in' in functional
mode). TX_IN and RX_IN can be used to determine a
wakeup source. Note that wakeup source detection
relies on the external transceiver functionality.
17 RX_IN R W Undefined LIN receiver input ('rx_in', 'lin_rx_in' in functional
mode).
24 TX_OUT R W 1 LIN transmitter output ('tx_out', 'lin_tx_out').
1056
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers

Table of Contents

Other manuals for Infineon TRAVEO T2G

Related product manuals