Infineon TRAVEO T2G - 3.8.6.12 CM0 P_CTI_CTIGATE

Technical Reference Manual 002-29852 Rev. *B
3.8.6.12 CM0P_CTI_CTIGATE
Description:
Enable CTI Channel Gate Register
Address:
0xF0002140
Offset:
0x140
Retention:
Retained
IsDeepSleep:
No
Comment:
The Gate Enable Register prevents the channels from propagating through the CTM to other
CTIs. This enables local cross-triggering, for example for causing an interrupt when the ETM
trigger occurs. It can be used effectively with CTIAPPSET, CTIAPPCLEAR, and
CTIAPPPULSE for asserting trigger outputs by asserting channels, without affecting the rest of
the system. On reset, this register is 0xF, and channel propagation is enabled.
Default:
0xF
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:4] CTIGATEEN
3 [3:3]
CTIGATEEN
2 [2:2]
CTIGATEEN
1 [1:1]
CTIGATEEN
0 [0:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0 CTIGATEEN0 RW R 1 Enable CTICHOUT0. Set to 0 to disable channel
propagation.
1 CTIGATEEN1 RW R 1 Enable CTICHOUT1. Set to 0 to disable channel
propagation.
2 CTIGATEEN2 RW R 1 Enable CTICHOUT2. Set to 0 to disable channel
propagation.
3 CTIGATEEN3 RW R 1 Enable CTICHOUT3. Set to 0 to disable channel
propagation.
242
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers