Infineon TRAVEO T2G - 19.5.1.7 PASS_SAR_DIG_CAL_ALT

Technical Reference Manual 002-29852 Rev. *B
19.5.1.7 PASS_SAR_DIG_CAL_ALT
Description:
Alternate digital calibration values
Address:
0x40900094
Offset:
0x94
Retention:
Retained
IsDeepSleep:
No
Comment:
First use analog calibration to avoid saturation for the required input voltage range. Then use
this digital calibration to map codes on full 12-bit range.
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name DOFFSET [7:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:12] DOFFSET [11:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:22] DGAIN [21:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0:11 DOFFSET RW R 0 See corresponding DIG_CAL field
16:21 DGAIN RW R 0 See corresponding DIG_CAL field
1096
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers