Infineon TRAVEO T2G - 7.5.3.6 CXPI_CH_TX_RX_STATUS

Technical Reference Manual 002-29852 Rev. *B
7.5.3.6 CXPI_CH_TX_RX_STATUS
Description:
TX/RX status
Address:
0x40518040
Offset:
0x40
Retention:
Not Retained
IsDeepSleep:
No
Comment:
Default:
0x5000000
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:18] RX_IN
[17:17]
TX_IN
[16:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:27] EN_OUT
[26:26]
None
[25:25]
TX_OUT
[24:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
16 TX_IN R W Undefined CXPI transmitter input ('tx_in', 'cxpi_tx_in' in functional
mode). TX_IN and RX_IN can be used to determine a
wakeup source. Note that wakeup source detection
relies on the external transceiver functionality.
17 RX_IN R W Undefined CXPI receiver input ('rx_in', 'cxpi_rx_in' in functional
mode).
24 TX_OUT R W 1 CXPI transmitter output ('tx_out', 'cxpi_tx_out').
26 EN_OUT RW RW 1 CXPI transceiver enable ('en_out', 'cxpi_en_out'). This
field controls the enable (or low active sleep enable) of
the external transceiver:
'0': Disabled.
'1': Enabled.
If CTL0.AUTO_EN is '0', SW controls this field to
enable the external transceiver. If CTL0.AUTO_EN is
'1', HW controls this field to enable the external
transceiver:
- HW sets this field to '1' when it is out of Sleep state. If
it moves to Sleep state, HW will clear this field to '0'.
779
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers