Infineon TRAVEO T2G - 2.3.9.6.38 CANFD_CH_TXBAR

Technical Reference Manual 002-29852 Rev. *B
2.3.9.6.38 CANFD_CH_TXBAR
Description:
Tx Buffer Add Request
Address:
0x405200D0
Offset:
0xD0
Retention:
Retained
IsDeepSleep:
No
Comment:
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name AR [7:0]
Bits 15 14 13 12 11 10 9 8
Name AR [15:8]
Bits 23 22 21 20 19 18 17 16
Name AR [23:16]
Bits 31 30 29 28 27 26 25 24
Name AR [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0:31 AR RW RW 0 Add Request
Each Tx Buffer has its own Add Request bit. Writing a
'1' will set the corresponding Add Request
bit; writing a '0' has no impact. This enables the Host
to set transmission requests for multiple Tx
Buffers with one write to TXBAR. TXBAR bits are set
only for those Tx Buffers configured via TXBC.
When no Tx scan is running, the bits are reset
immediately, else the bits remain set until the Tx scan
process has completed.
0= No transmission request added
1= Transmission requested added
95
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers