Technical Reference Manual 002-29852 Rev. *B
26.8.51.10 WDT_INTR_SET
Description:
WDT Interrupt Set Register
Address:
0x4026C054
Offset:
0x54
Retention:
Retained
IsDeepSleep:
No
Comment:
Can be used to set interrupts for firmware testing.
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:1] WDT [0:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0 WDT RW1S A 0 Set interrupt.
Due to internal synchronization, it takes up to 8
SYSCLK cycles to update after a W1S or reading from
this register and during this time AHB bus is stalled.
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers
To Next Page
Loading...
