Infineon TRAVEO T2G - 13.5.1.3 FAULT_STRUCT_DATA

Technical Reference Manual 002-29852 Rev. *B
13.5.1.3 FAULT_STRUCT_DATA
Description:
Fault data
Address:
0x40210010
Offset:
0x10
Retention:
Retained
IsDeepSleep:
No
Comment:
The DATA registers capture fault information.
These register use cold reset (and are NOT affected by Active or DeepSleep reset). This
allows for failure analysis after a warm reset (DeepSleep reset).
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name DATA [7:0]
Bits 15 14 13 12 11 10 9 8
Name DATA [15:8]
Bits 23 22 21 20 19 18 17 16
Name DATA [23:16]
Bits 31 30 29 28 27 26 25 24
Name DATA [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0:31 DATA RW W Undefined Captured fault source data.
Note: the DATA registers can only be written when
STATUS.VALID is '0'.
Note: the fault source index STATUS.IDX specifies the
format of the DATA registers.
924
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers