Infineon TRAVEO T2G - 14.2.27.12 FLASHC_STATUS

Technical Reference Manual 002-29852 Rev. *B
14.2.27.12 FLASHC_STATUS
Description:
Status read from Flash Macro
Address:
0x4024F404
Offset:
0x404
Retention:
Not Retained
IsDeepSleep:
No
Comment:
Read out by the CPUSS to understand the Flash Macro status
Default:
0x80000000
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:7] BLANK
_CHCEK
_PASS [6:6]
BLANK
_CHECK
_WORK
[5:5]
ERS
_SUSPEND
[4:4]
ERASE
_WORK
[3:3]
ERASE
_CODE
[2:2]
PGM
_WORK
[1:1]
PGM
_CODE
[0:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name BUSY
[31:31]
HANG
[30:30]
NATIVE
_POR
[29:29]
POR_2B
_ECC
_ERROR
[28:28]
POR_1B
_ECC
_CORRECTE
D [27:27]
None [26:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0 PGM_CODE R W 0 Indicates if active PGM operation to the Code flash is
taking place
0: not running
1: running
1 PGM_WORK R W 0 Indicates if active PGM operation to the Work flash is
taking place
0: not running
1: running
2 ERASE_CODE R W 0 Indicates if active Erase operation to the Code flash is
taking place
0: not running
1: running
3 ERASE_WORK R W 0 Indicates if active Erase operation to the Work flash is
taking place
0: not running
1: running
4 ERS_SUSPEND R W 0 Indicates if Erase operation (Code/Work) is currently
being suspended
0: not suspended
1: suspended
5 BLANK_CHECK_WORK R W 0 Indicates if Blank Check mode is currently running on
the work flash
0: not running
1: running
6 BLANK_CHCEK_PASS R W 0 Indicates the Blank check command result is PASS
(Blank)
0: Not Blank
1: Blank (PASS)
976
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers