Infineon TRAVEO T2G - 19.5.1.10 PASS_SAR_WORK_VALID

Technical Reference Manual 002-29852 Rev. *B
19.5.1.10 PASS_SAR_WORK_VALID
Description:
Channel working data register 'valid' bits
Address:
0x40900180
Offset:
0x180
Retention:
Not Retained
IsDeepSleep:
No
Comment:
bits of disabled channels will be reset
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name WORK_VALID [7:0]
Bits 15 14 13 12 11 10 9 8
Name WORK_VALID [15:8]
Bits 23 22 21 20 19 18 17 16
Name WORK_VALID [23:16]
Bits 31 30 29 28 27 26 25 24
Name WORK_VALID [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0:31 WORK_VALID R RW 0 If set the corresponding WORK register is valid, i.e.
was already acquired during the current group scan. If
this bit is low then either the channel is not enabled,
not yet acquired or it is used as a pulse detect
channel.
1099
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers