Infineon TRAVEO T2G - 4.13.8.2 CM4_TRCCTI_CTIINTACK

Technical Reference Manual 002-29852 Rev. *B
4.13.8.2 CM4_TRCCTI_CTIINTACK
Description:
CTI Interrupt Acknowledge Register
Address:
0xE0080010
Offset:
0x10
Retention:
Retained
IsDeepSleep:
No
Comment:
The CTI Interrupt Acknowledge Register is write-only. Any bits written as a 1 cause the
CTITRIGOUT output signal to be acknowledged. The acknowledgement is cleared when
MAPTRIGOUT is deactivated. This register is used when the CTITRIGOUT is used as a sticky
output, that is, no hardware acknowledge is supplied, and a software acknowledge is required.
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name INTACK [7:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0:7 INTACK W R 0 Acknowledges the corresponding CTITRIGOUT
output:
1 = CTITRIGOUT is acknowledged and is cleared
when MAPTRIGOUT is LOW. 0 = no effect.
There is one bit of the register for each CTITRIGOUT
output.
541
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers