Infineon TRAVEO T2G - 15.25.7.4 GPIO_PRT_OUT_INV

Technical Reference Manual 002-29852 Rev. *B
15.25.7.4 GPIO_PRT_OUT_INV
Description:
Port output data invert register
Address:
0x4031000C
Offset:
0xC
Retention:
Retained
IsDeepSleep:
No
Comment:
Used to invert output data of specific IO pins in the corresponding port, without affecting the
output data of the other IO pads in the port. A register read returns the same value as an OUT
register read.
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name OUT7 [7:7] OUT6 [6:6] OUT5 [5:5] OUT4 [4:4] OUT3 [3:3] OUT2 [2:2] OUT1 [1:1] OUT0 [0:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0 OUT0 RW A 0 IO invert output for pin 0:
'0': Output state not affected.
'1': Output state inverted ('0' => '1', '1' => '0').
1 OUT1 RW A 0 IO invert output for pin 1
2 OUT2 RW A 0 IO invert output for pin 2
3 OUT3 RW A 0 IO invert output for pin 3
4 OUT4 RW A 0 IO invert output for pin 4
5 OUT5 RW A 0 IO invert output for pin 5
6 OUT6 RW A 0 IO invert output for pin 6
7 OUT7 RW A 0 IO invert output for pin 7
999
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers