Infineon TRAVEO T2G - 26.8.29 CLK_ECO_STATUS

Technical Reference Manual 002-29852 Rev. *B
26.8.29 CLK_ECO_STATUS
Description:
ECO Status Register
Address:
0x40261524
Offset:
0x1524
Retention:
Retained
IsDeepSleep:
Yes
Comment:
Status indications for external crystal oscillator (ECO).
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:2] ECO
_READY
[1:1]
ECO_OK
[0:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0 ECO_OK R W 0 Indicates the ECO internal oscillator circuit has
sufficient amplitude. It may not meet the PPM
accuracy or duty cycle spec.
1 ECO_READY R W 0 Indicates the ECO internal oscillator circuit has had
enough time to fully stabilize. This is the output of a
counter since ECO was enabled, and it does not check
the ECO output. It is recommended to also confirm
ECO_OK==1.
1669
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers