Infineon TRAVEO T2G - 23.9.17 SCB_I2 C_S_CMD

Technical Reference Manual 002-29852 Rev. *B
23.9.17 SCB_I2C_S_CMD
Description:
I2C slave command
Address:
0x4060006C
Offset:
0x6C
Retention:
Not Retained
IsDeepSleep:
No
Comment:
The register fields are not retained. This is to ensure that they come up as '0' after coming out
of DeepSleep system power mode.
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:2] S_NACK
[1:1]
S_ACK
[0:0]
Bits 15 14 13 12 11 10 9 8
Name None [15:8]
Bits 23 22 21 20 19 18 17 16
Name None [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0 S_ACK RW RW1C 0 When '1', attempt to transmit an acknowledgement
(ACK). When this action is performed, the hardware
sets this field to '0'. In EZ mode, this field should be set
to '0' (it is only to be used in non EZ mode).
1 S_NACK RW RW1C 0 When '1', attempt to transmit a negative
acknowledgement (NACK). When this action is
performed, the hardware sets this field to '0'. In EZ
mode, this field should be set to '0' (it is only to be
used in non EZ mode). This command has a higher
priority than I2C_S_CMD.S_ACK,
I2C_CTRL.S_READY_ADDR_ACK or
I2C_CTRL.S_READY_DATA_ACK.
1413
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers