Infineon TRAVEO T2G - 26.8.28 CLK_ECO_PRESCALE

Technical Reference Manual 002-29852 Rev. *B
26.8.28 CLK_ECO_PRESCALE
Description:
ECO Prescaler Configuration Register
Address:
0x40261520
Offset:
0x1520
Retention:
Retained
IsDeepSleep:
Yes
Comment:
Fractional prescaler value to bring down the ECO frequency to 32768 Hz if used as LFCLK.
Do not change divider settings while ECO prescaler is enabled or enabling.
Default:
0x0
Bit-field Table
Bits 7 6 5 4 3 2 1 0
Name None [7:1] ECO_DIV
_ENABLED
[0:0]
Bits 15 14 13 12 11 10 9 8
Name ECO_FRAC_DIV [15:8]
Bits 23 22 21 20 19 18 17 16
Name ECO_INT_DIV [23:16]
Bits 31 30 29 28 27 26 25 24
Name None [31:26] ECO_INT_DIV [25:24]
Bit-fields
Bits Name SW HW Default or
Enum
Description
0 ECO_DIV_ENABLED R RW 0 ECO prescaler enabled. HW sets this field to '1' as a
result of an CLK_ECO_CONFIG.ECO_DIV_ENABLE
command. HW sets this field to '0' as a result on a
CLK_ECO_CONFIG.ECO_DIV_DISABLE command.
8:15 ECO_FRAC_DIV RW R 0 8-bit fractional value, sufficient to get prescaler output
within the +/-65ppm calibration range. Do not change
this setting when ECO Prescaler is enabled.
16:25 ECO_INT_DIV RW R 0 10-bit integer value allows for ECO frequencies up to
33.55MHz. Subtract one from the desired divide value
when writing this field. For example, to divide by 1,
write ECO_INT_DIV=0. Do not change this setting
when ECO Prescaler is enabled.
1668
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers