Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
26 EN_OUT RW RW 1 LIN transceiver enable ('en_out', 'lin_en_out'). This
field controls the enable (or low active sleep enable) of
the external transceiver:
'0': Disabled.
'1': Enabled.
If CTL.AUTO_EN is '0', SW controls this field to enable
the external transceiver. If CTL.AUTO_EN is '1', HW
controls this field to enable the external transceiver:
- Before a legal command sequence, HW sets this field
to '1', if it is '0'. The start of the command sequence is
effectively postponed by a 4-bit period preamble.
- After a legal command sequence, HW clears this field
to '0'. The end of the command sequence is effectively
postponed by a 4-bit period postamble.
Note: external transceivers require a 'power up' or
'power down' period of 1 or 2 bit periods, so a 4-bit
period suffices for all known transceivers.
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers
To Next Page
Loading...
