Infineon TRAVEO T2G - Page 1042

Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
21 TX_DATA_STOP
_ERROR
RW R 0 The data field STOP bits are inverted to '0'.
At the receiver, this should result in
INTR.RX_RESPONSE_FRAME_ERROR activation.
Note: Used in UART mode.
22 TX_CHECKSUM_ERROR RW R 0 The checksum field is inverted.
At the receiver, this should result in
INTR.RX_RESPONSE_CHECKSUM_ERROR
activation.
23 TX_CHECKSUM_STOP
_ERROR
RW R 0 The checksum field STOP bits are inverted to '0'.
At the receiver, this should result in
INTR.RX_RESPONSE_FRAME_ERROR activation.
31 ENABLED RW R 0 Error injection enable:
'0': Disabled.
'1': Enabled.
1042
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers