Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
25 CTS_ENABLED RW R 0 Enable use of CTS input signal by the UART
transmitter:
'0': Disabled. The UART transmitter ignores the CTS
input signal and transmits when a data frame is
available for transmission in the TX FIFO or the TX
shift register.
'1': Enabled. The UART transmitter uses CTS input
signal to qualify the transmission of data. It transmits
when CTS input signal is active and a data frame is
available for transmission in the TX FIFO or the TX
shift register.
If UART_CTRL.LOOPBACK is '1', the CTS input signal
is driven by the RTS output signal locally in SCB (both
signals are subjected to signal polarity changes are
indicated by RTS_POLARITY and CTS_POLARITY).
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers
To Next Page
Loading...
