Infineon TRAVEO T2G - Page 1446

Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
9 UART_DONE RW1C RW1S 0 UART transmitter done event. This happens when the
IP is done transferring all data in the TX FIFO, and the
last stop field is transmitted (both TX FIFO and
transmit shifter register are empty). Set to '1', when
event is detected. Write with '1' to clear bit.
10 UART_ARB_LOST RW1C RW1S 0 UART lost arbitration: the value driven on the TX line is
not the same as the value observed on the RX line.
This condition event is useful when transmitter and
receiver share a TX/RX line. This is the case in LIN or
SmartCard modes. Set to '1', when event is detected.
Write with '1' to clear bit.
1446
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers