Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
14 HVLVD2_DPSLP_EN_HT RW R 0 Keep HVLVD2 voltage monitor enabled during
DEEPSLEEP mode. This field is only used when
HVLVD1_EN_HT==1.
15 HVLVD2_EN_HT RW R 0 Enable HVLVD2 voltage monitor. This detector
monitors vddd only. Do not change other HVLVD2
settings when enabled.
16:17 HVLVD2_EDGE_SEL RW R 0 Sets which edge(s) will trigger an action when the
threshold is crossed.
DISABLE 0 Disabled
RISING 1 Rising edge
FALLING 2 Falling edge
BOTH 3 Both rising and falling edges
18 HVLVD2_ACTION RW R 0 Action taken when the threshold is crossed in the
programmed directions(s)
INTERRUPT 0 Generate an interrupt
FAULT 1 Generate a fault
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers
To Next Page
Loading...
