Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
31 DEBUG_RUN RW A 0 Pauses/runs this counter while a debugger is
connected. Other behaviors are unchanged during
debugging, including service, configuration updates
and enable/disable. Note it may take up to two clk_ilo0
cycles for the counter to pause and another two cycles
to unpause, due to internal synchronization. If the
debugger is connected for at least two clk_ilo0 cycles,
the LOWER_ACTION is ignored until after the first
service after the debugger is disconnected. This
prevents an unintentional trigger of the
LOWER_ACTION before the firmware realigns the
servicing period. After the first service,
LOWER_ACTION behaves as configured. If the
debugger is disconnected before two clk_ilo0 cycles,
the LOWER_ACTION may or may not be ignored.
0: When debugger connected, counter pauses
incrementing as configured in DEBUG_TRIGGER_EN.
1: When debugger connected, counter increments
normally, but reset generation is blocked.
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers
To Next Page
Loading...
