Infineon TRAVEO T2G - Page 1815

Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
8:9 START_EDGE RW R 3 A start event will start the counter; i.e. the counter will
become running. Starting does NOT enable the
counter. A start event will not initialize the counter
whereas the reload event does.
RISING_EDGE 0 Rising edge. Any rising edge generates an event.
FALLING_EDGE 1 Falling edge. Any falling edge generates an event.
ANY_EDGE 2 Rising AND falling edge. Any odd amount of edges
generates an event.
NO_EDGE_DET 3 No edge detection, use trigger as is.
10:11 CAPTURE1_EDGE RW R 3 A capture 1 event will copy the counter value into the
CC1 register.
RISING_EDGE 0 Rising edge. Any rising edge generates an event.
FALLING_EDGE 1 Falling edge. Any falling edge generates an event.
ANY_EDGE 2 Rising AND falling edge. Any odd amount of edges
generates an event.
NO_EDGE_DET 3 No edge detection, use trigger as is.
1815
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers