Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
4:7 PC RW R 0 Protection context.
This field is set with the protection context of the
transaction that writes this register; i.e. the context is
inherited from the write transaction and not specified
by the transaction write data.
All transactions for this channel uses the PC field for
the protection context.
8:9 PRIO RW R 0 Channel priority:
'0': highest priority.
'1'
'2'
'3': lowest priority.
Channels with the same priority constitute a priority
group and within this priority group, the following
'roundrobin' arbitration is applied.
A 'round' consists of a contiguous sequence of channel
activations, within this priority group, without any
repetition. Within a round, higher priority is given to the
lower channel indices. The notion of a round
guarantees that within a group, higher channel indices
do not yield to lower indices indefinitely.
31 ENABLED RW RW1C 0 Channel enable:
'0': Disabled. The channel's trigger is ignored and the
channel cannot be made pending and therefore cannot
be made active. If a pending channel is disabled, the
channel is made non pending. If the activate channel is
disabled, the channel is de-activated (bus transactions
are completed).
'1': Enabled.
SW sets this field to '1' to enable a specific channel.
HW sets this field to '0' when an error interrupt cause
is activated.
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers
To Next Page
Loading...
