Infineon TRAVEO T2G - Page 965

Technical Reference Manual 002-29852 Rev. *B
Bits Name SW HW Default or
Enum
Description
0:4 FM_MODE RW R 0 Flash macro mode selection:
d0: Read/Idle - Normal mode, read array enabled
d1: Not Used - the 1st analog POR is done by
enable/enable_hv
d2 - POR FUR Download - Downloads critical Flash
initialization data from OTP (BG, rd, redu, etc....)
d3 - POR IRAM MMR Download - Downloads from
OTP region the MMR / IRAM into to the 8051 RDL
shadows
d4 - POR SW Download - Downloads from OTP region
the SW code into to the 8051 MCU SRAM
d5 - POR Code_Work Prepare - Loads the Code and
Work Flash MG's to be ready for user mode operation
d6 - Not Used
d7 - Program 32b (WORK) - Used as program confirm
command for 32 (Work) bits program
d8 - Program 64b (CODE) - Used as program confirm
command for 64 (Code) bits program
d9 - Program 256b (CODE) - Used as program confirm
command for 256 (Code) bits program
d10: Program Page (CODE) - Used as program
confirm command for page program for Code flash
d11: Not Used
d12 - Sector Erase - Erase for all kinds of sectors
(Code/Work/SMS)
d13 - Blank check Entry (UBC)
d14 - Blank Check Read 32bit (WORK) - Blank check
mode
d15 - Blank check Exit
d16 - Not Used
d17 - Erase Suspend - Suspend command to the
Erase operation
d18 - Erase Resume - Resume command to Erase
suspended operation
d19 - Not Used
d20- Not Used
d21- Not Used
d22- Not Used
d23- Not Used
d24- Not Used
d25- Not Used
d26- Not Used
d27- Not Used
d28- Not Used
d29- Not Used
d30: Not Used
d31: Not Used
31 EMB_START RW R 0 '0': not active
'1': starts the actual embedded operation
965
2022-04-18
TRAVEO™ T2G Automotive MCU: TVII-B-E-4M body controller entry registers