C613-50100-01 REV C Command Reference for x930 Series 1008
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPF COMMANDS
OSPF
RESTART HELPER
ospf restart helper
Overview Use this command to configure the helper behavior for the OSPF Graceful Restart
feature.
Use the no variant of this command to revert to the default grace-period.
Syntax
ospf restart helper {max-grace-period
<grace-period>|only-reload|only-upgrade}
ospf restart helper {never router-id <router-id>}
no ospf restart helper [max-grace-period]
Default In the AlliedWare Plus™ OSPF implementation, the default OSPF grace-period is
180 seconds.
Mode Global Configuration
Usage The ospf restart helper command requires at least one parameter, but you may
use more than one in the same command (excluding parameter never).
The no version of this command turns off the OSPF restart helper, while the no
ospf restart helper max-grace-period command resets the max-grace-period,
rather than the helper policy itself.
Example
awplus# configure terminal
awplus(config)# ospf restart helper only-reload
awplus# configure terminal
awplus(config)# ospf restart helper never router-id 10.10.10.1
awplus# configure terminal
awplus(config)# no ospf restart helper max-grace-period
Parameter Description
max-grace-period Specify help if received grace-period is less than a specified
value.
<grace-period> Maximum grace period accepted in seconds in range <1-
1800>.
never Specify the local policy to never to act as a helper for this
feature.
only-reload Specify help only on software reloads not software upgrades.
only-upgrade Specify help only on software upgrades not software reloads.
router-id Enter the router-id keyword to specify the OSPF Router ID that
is never to act as a helper for the OSPF Graceful Restart feature.
<router-id> <A.B.C.D>
Specify the OSPF Router ID in dotted decimal format A.B.C.D
To Next Page
Loading...
Need help?
General
