C613-50100-01 REV C Command Reference for x930 Series 2994
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
SECURE SHELL (SSH) COMMANDS
SSH
SERVER RESOLVE-HOST
ssh server resolve-host
Overview This command enables resolving an IP address from a host name using a DNS
server for client host authentication.
The no variant of this command disables this feature.
Syntax
ssh server resolve-hosts
no ssh server resolve-hosts
Default This feature is disabled by default.
Mode Global Configuration
Usage Your device has a DNS Client that is enabled automatically when you add a DNS
server to your device. Use the ip name-server command to add a DNS server to the
list of servers that the device queries.
For information about configuring DNS, see the Internet Protocol Feature
Overview and Configuration Guide.
Example To resolve a host name using a DNS server, use the commands:
awplus# configure terminal
awplus(config)# ssh server resolve-hosts
Related
Commands
ip name-server
show ssh server
ssh server allow-users
ssh server deny-users
To Next Page
Loading...
