C613-50100-01 REV C Command Reference for x930 Series 1045
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
OSPF COMMANDS
SHOW
IP OSPF VIRTUAL-LINKS
show ip ospf virtual-links
Overview Use this command to display virtual link information.
For information on filtering and saving command output, see the “Getting Started
with AlliedWare Plus” Feature Overview and Configuration Guide.
Syntax
show ip ospf virtual-links
Mode User Exec and Privileged Exec
Examples To display virtual link information, use the command:
awplus# show ip ospf virtual-links
Output Figure 26-22: Example output from the show ip ospf virtual-links command
Virtual Link VLINK0 to router 10.10.0.9 is up
Transit area 0.0.0.1 via interface vlan5
Transmit Delay is 1 sec, State Point-To-Point,
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in 00:00:02
Adjacency state Full
Virtual Link VLINK1 to router 10.10.0.123 is down
Transit area 0.0.0.1 via interface *
Transmit Delay is 1 sec, State Down,
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5
Hello due in inactive
Adjacency state Down
To Next Page
Loading...
Need help?
General
